Skutch-electronics BA-1000-A V4.00 Technical Reference Manual Bedienungsanleitung PDF herunterladen (Seite 7)

Version 4.00 Page 7

FCC No: AP494N-64812-MA-E

RINGER EQ.:0.0B

USOC No (Jack type) RJ-11, RJ-12, or RJ-13

(See telephone connection)

Power Up

To power the unit up;

1) Make sure that the Microphone is disconnected

from the BA-1000-A.

2) Connect the supplied POWER ADAPTER to the

POWER jack on the rear panel of the BA-1000-

A. This MUST be done before the POWER

ADAPTER is connected to 115VAC power.

3) Now connect the POWER ADAPTER to a

115VAC 60Hz power outlet.

! Diagnostic Test

Every time the BA-1000 is powered up, it

performs a series of diagnostic tests as follows:

The display shows the initial splash screen:

- Initializing -

-- Zip Drive --

The display shows the initial splash screen:

Skutch Elec, Inc

Then it sets up the phone line circuits, showing:

- Initializing –

Phone line CODEC

Then it sets up the mic circuits, showing:

- Initializing –

Microphone CODEC

Then the system will calibrate the microphone

input. Make sure the no audio source or microphone

is PLUGGED in while the system says:

Remove MIC While

Calibrating!

After 8 seconds, the system will show:

Now POWERING UP

primary systems.

Then the system will show:

- Initializing -

-- Zip Drive --

Then it will test the ZIP drive and show the

following:

Testing Zip Disk

– Please Wait -

Then it will test all the files on the system,

showing:

-Testing Files-

- Please Wait -

The system will update the number in the top

right to show the current file being tested. When all

tests are done the system will show the following:

>System On Line<

100% Functional!

Then the system will put you at the MENU, as

follows:

--Idle--Ver 4.00

11/01/01 08:00am

Idle Mode

In this mode the BA-1000-A will not answer

incoming telephone calls. You MUST be in IDLE

mode to initiate any of the following:

" To TEST or RECORD your outgoing

message.

" To PLAY CALLS locally.

" To enter AUTO ANSWER mode.

" To enter POWER DOWN mode.

" To program NOTIFICATION Phone

Numbers.

" To change the system SETUP

parameters.

To return the unit to IDLE mode from other

modes simply press ~

While in Idle Mode, you can call the system to

remotely change it to Answer Mode; the system

will answer after the 10

ring, then just go into

Remote Mode to change the state.

1 2 3 4 5 6 7 8 9 10 11 12 ... 25 26

Kommentare zu diesen Handbüchern

Keine Kommentare

Skutch-electronics BA-1000-A V4.00 Technical Reference Manual Bedienungsanleitung Seite 7

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Ausrüstung Skutch-electronics BA-1000-A V4.00 Technical Reference Manual